Metal stamping is a cold-forming process that makes use of dies and stamping presses to transform sheet metal into different shapes. Pieces of flat sheet metal, typically referred to as blanks, is fed into a sheet metal stamping press that uses a tool and die surface to form the metal into a new shape. Production facilities and metal fabricators offering stamping services will place the material to be stamped between die sections, where the use of pressure will shape and shear the material into the desired final shape for the product or component.

This article describes the metal stamping process and steps, presents the types of stamping presses typically employed, looks at the advantages of stamping compared to other fabrication processes, and explains the different types of stamping operations and their applications.

Basic Concepts of Metal Stamping

Metal stamping, also referred to as pressing, is a low-cost high-speed manufacturing process that can produce a high volume of identical metal components. Stamping operations are suitable for both short or long production runs, and be conducted with other metal forming operations, and may consist of one or more of a series of more specific processes or techniques, such as:

As you know,the conduit fittings as attachment or accessories for electrical conduit,so we called electrical fitting,conduit fitting or conduit accessories in general.They are used for connect the conduit for easier run the wires in whole house and connect to your electronic appliance.Different conduit has different fitting for connect,you must be pay more attention the size and standard before purchased.

The Benefits of Electrical Fittings

Hot-dip galvanizing and cold galvanized the difference:

1. Galvanizing, also known as hot-dip galvanized, he is the ingot melted at high temperatures, a number of supplementary material in place, then dipped galvanized metal structure slot, the metal component on a layer of zinc coating . The advantages of hot-dip galvanizing corrosion of his ability, adhesion and hardness of zinc coating is better

“Cold plated” or “plating”, ie the zinc salt solution by electrolysis, to the plating on the coating, generally do not have heating, small amount of zinc, the wet environment is very easy to fall off.

2. Hot dip galvanized (galvanizing)

Hot-dip galvanizing is a chemical treatment, is the electrochemical reaction.
Cold galvanizing is the physical address, just brush the surface layer of zinc, the zinc layer is easy to fall off. Construction in the use of hot dip galvanizing.

All-dielectric self-supporting (ADSS) cable is a type of optical fiber cable that is strong enough to support itself between structures without using conductive metal elements. It is used by electrical utility companies as a communications medium, installed along existing overhead transmission lines and often sharing the same support structures as the electrical conductors.

ADSS is an alternative to OPGW and OPAC with lower installation cost. The cables are designed to be strong enough to allow lengths of up to 700 metres to be installed between support towers. ADSS cable is designed to be lightweight and small in diameter to reduce the load on tower structures due to cable weight, wind, and ice.

In the design of the cable, the internal glass optical fibers are supported with little or no strain, to maintain low optical loss throughout the life of the cable. The cable is jacketed to prevent moisture from degrading the fibers. The jacket also protects the polymer strength elements from the effect of solar ultraviolet light.

Using single-mode fibers and light wavelengths of either 1310 or 1550 nanometres, circuits up to 100 km long are possible without repeaters. A single cable can carry as many as 864 fibers.

What is overhead line fitting?

Overhead line fitting is a wide range of steel fittings that are used to construct the overhead lineit is used to hang, connect or protect conductors or insulators.

Overhead line fitting is also called overhead line hardware or overhead line accessories.

According to the function, overhead line fittings can be divided into:

String hardware

Suspension clamp

Tension clamp

Splicing fitting

Protective fitting

Dead end fitting